安装出错，会的人来那分

我安装passthru.sys后用drivermontior查看调试信息，
open passthru.sys后 用start启动 出错
Monitor ERROR (1058): The driver is marked as disabled (Start=4) in its service database entry.
8.282 Default Passthru: PtUnload: entered
8.282 Default Passthru: PtUnloadProtocol: done!
8.282 Default Passthru: PtUnload: done!

这是怎么会事，如何打开service database entry

据ddk :

Drivers should follow these rules for specifying StartType:

PnP driver
A PnP driver should have a start type of SERVICE_DEMAND_START (0x3), specifying that the PnP Manager can load the driver whenever the PnP Manager finds a device that the driver services.

Driver for a device required to boot the machine
If a device is required to boot the machine, the drivers for the device should have a start type of SERVICE_BOOT_START (0x0).

Non-boot driver that detects device(s) that are not PnP-enumerable
For a device that is not PnP-enumerable, a driver reports the device to the PnP Manager by calling IoReportDetectedDevice. Such a driver should have the start type SERVICE_SYSTEM_START (0x01), so Setup will load the driver during system initialization.

Only drivers that report nonPnP hardware should set this start type. If a driver services both PnP and nonPnP devices, the driver should set this start type.

NonPnP driver that must be started by the Service Control Manager
Such a driver should have the start type SERVICE_AUTO_START (0x02). PnP drivers must not set this start type.

经查证 ：

Start(3) 指出系统应动态装入这个驱动程序。(该值与CreateService中的SERVICE_DEMAND_START常量对应，用于内核模式驱动程序时它代表不必明确调用StartService函数或发出NET START命令来启动驱动程序)

各位大哥，见笑了。我到底是怎么错了?
 
可否指点？ 先谢过了

同意

用ezDrvInstaller 来安装是没错，但是 drivermoniter 可以显示 wdm输出的 信息。

但是你说的情况我觉得是在 inf 中 的 install.nt.service 中 start = 3 ,你现在是 = 4 ，相当于把驱动禁止了

 找本inf看看！

用ezDrvInstaller 来安装是没错，但是 drivermoniter 可以显示 wdm输出的 信息。

但是你说的情况我觉得是在 inf 中 的 install.nt.service 中 start = 3 ,你现在是 = 4 ，相当于把驱动禁止了

我来灌灌水:
其实以前的帖子中有类似问题的回答.
结论是:
driver monitor 不能用来用服务的方式动态加载WDM驱动,只能用来加载NT式的驱动.
要动态加载WDM可能需要DriverStudio/Tools/EzDrvInstaller