gaochizhen33
驱动牛犊
驱动牛犊
  • 注册日期2012-05-14
  • 最后登录2012-05-30
  • 粉丝0
  • 关注0
  • 积分2分
  • 威望11点
  • 贡献值0点
  • 好评度0点
  • 原创分0分
  • 专家分0分
阅读:2051回复:0

mib2c 转化mib文件出错,求教

楼主#
更多 发布于:2012-05-14 10:01
执行mib2c -c mib2c.scalar.conf if 的时候提示下列错误。
You didn't give mib2c a valid OID to start with.  IE, I could not find
any information about the mib node "if".  This could be caused
because you supplied an incorrectly node, or by the MIB that you're
trying to generate code from isn't loaded.  To make sure your mib is
loaded, run mib2c using this as an example:

  env MIBS="+MY-PERSONAL-MIB" mib2c -c mib2c.scalar.conf if

You might wish to start by reading the MIB loading tutorial at:
And making sure you can get snmptranslate to display information about
your MIB node.  Once snmptranslate works, then come back and try mib2c
again.


我用snmpwalk IF-MIB可以成功,这是什么问题啊?我用的是net-snmp 5.3.4版本
游客

返回顶部