其他地方也一样

在7.3.3 Details of transaction layer operation中：
  Replace the list after the second paragraph in 7.3.3.1.2 with the following:
the second paragraph我也找不到啊，我越看越糊涂了：（

在7.3.3 Details of transaction layer operation中：
  Replace the list after the second paragraph in 7.3.3.1.2 with the following:
the second paragraph我也找不到啊，我越看越糊涂了：（  

怎么可能找不到呢?我上个月刚翻译一遍,呵呵.
1394a-2000中修改1394-1995中的相应条文.
7.3.3.1.2 Sending a transaction request
Transition TX0:TX1. The transaction layer receives a transaction data request. The transaction layer shall transition
to state TX1.
State TX1: Send Transaction Request. The transaction layer shall initiate a transaction by communicating a link data
request to the link layer to cause the request subaction of the transaction to be sent to the specified destination node.
The retry code of the request shall be set to retry_1 for the first attempt to send the subaction. A transaction label that
uniquely identifies the transaction to the destination node (see 6.2.4.3) shall be specified by the transaction layer. The
destination address, extended transaction code, speed, priority, data length, and data parameters of the link data request
shall be set to the values of the corresponding fields contained in the transaction data request. The transaction code
parameter value shall be set to
Replace the list after the second paragraph in 7.3.3.1.2 with the following:― Write request for data quadlet, if the transaction type value in the transaction data request is WRITE,