讨论，关于VxWorks的启动

讨论，关于VxWorks的启动
配置环境：
dell电脑: Intell Pentium4 1.8G, 256M内存
Win2000 + SP4
VMware 4.52 build 8848
Tornado 2.0 for x86 + BSP
Tornado 2.2 for x86 + BSP
目标：
只要最简单的软盘启动成功既可。

在不同目录下安装Tornado2.0和2.2成功，针对两个Tornado平台分别新建了两个booable for Pentium的project。
两个project均不做任何改动，直接生成bootrom_uncmp文件。
分别用两Tornado平台的mkboot.bat将bootrom_uncmp文件安装到软盘中。
最后发现：
在Tornado 2.0生成的bootrom_uncmp文件可以在VMware中启动成功，而Tornado 2.2缺不行。
各位推测原因何在？
（注：VMware环境没有问题，在其中安装win98后运行正常，且可与Win2000进行网络通讯）

I made a boot disk for my Pentium166,  after I inserted floppy, the monitor shows like following:

V1.6++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++++++RD!

and stop with RD! sometimes, because I don't have compatitable network card, So I changed the configure.I don't know what is going on, who can give me some idea??  thanks

e-mail : jason_fsm@yahoo.com

Jason

I have the same problem , If you know the answer ,please , tell me ,thank you ,
: myruru2005@yahoo.com.cn