阅读:1332回复:2
关于EZ-USB的FIRMWARE下载问题.
EZ-USB TRM上有这样一些资料.
If no off-chip memory (either on the I²C-compatible bus or on the address/data bus) is con-nected to the FX2, it enumerates as the Default USB Device, with descriptors and VID / PID / DID supplied by hardwired internal logic (Table 3-3). RENUM is set to 0, indicating that the Default USB Device automatically handles device requests. 我现在做的板子就是没有挂任何EEPROM或FLASH(只有IC必须的外围电路),插入主机时显示有一个\"EZ-USB......\"的设备插入,可我用EZ-USB控制面板把我自己的FIRMWARE下载下去的时候,没有任何反应,看起来是LOAD的FIRMWARE没去作用,不知道我这样子做对不对,谁能提点建议?谢谢. |
|
沙发#
发布于:2002-05-21 22:52
EZUSB定制设备必须要EEPROM,而且必须是MICROCHIP的EEPROM24LCxx
|
|
板凳#
发布于:2002-05-22 09:50
或者改inf与注册表也可以吧。
|
|